There is my mis-typing point.
In: serial
Out: serial
Err: serial
Net: EMAC0, EMAC1
BEDBUG:ready
Hit any key to stop autoboot: 0 --> *At this point - you can enter
PPC-Console mode*
booting secondary, press ^c to abort ---> *It's a leading to boot
from primary image*
booting...
Booting image at d0a00000 ...
Image Name: Linux Multiboot-Image 2.4.21-pmp
Created: 2006-08-24 11:41:03 UTC
Image Type: PowerPC Linux Multi-File Image (gzip compressed)
Data Size: 20363540 Bytes = 19886 kB = 19 MB
Load Address: 00000000
Entry Point: 00000000
Contents:
Image 0: 780651 Bytes = 762 kB = 0 MB
.
2013/6/7 최재훈 <inbusiness.jhchoi@gmail.com>
CAUTION!
IF YOU HAVE NOT CONSOLE CABLE, DON'T COMMIT FACTORY DEFAULT COMMAND on any
other IB switch.
Basically ISR9024D-M has a factory default configuration (192.168.1.2).
If you commit factory default command on CLI, you can connect default ip
address 192.168.1.2.
But another switches(Not ISR9024D-M) have default configuration DHCP for
management ethernet port.
If you want run the printenv command you must have a serial console cable.
I'm attache a normal ISR9024D-M boot log.
It was captured via console cable only.
You can run the printenv command in PPC-Boot console via serial console
cable.
>
.
.
.
PPCBoot 1.1.6 (Nov 16 2004 - 08:21:51)
CPU: IBM PowerPC 440 Rev. C
Board: Artesyn Technologies PM/PPC-440gp
Artesyn Monitor Version 1.5.0
VCO: 800 MHz
CPU: 400 MHz
PLB: 133 MHz
OPB: 66 MHz
EPB: 66 MHz
I2C: ready
DRAM: ECC Init ....Done 128 MB
FLASH: 64 MB
Initializing board as Monarch....
Scanning for PCI devices....
Scanning PCI devices on bus 0
LOCALE VEND DEV REV BASE0 BASE1 BASE2 BASE3 BASE4 BASE5