Hi!
I was used Mellanox Voltaire 4036 then transition to Mellanox 5035 QDR switch.
Mellanox 5035 have a Web GUI itself and it has a ability configure partition on it.
But I have a 2 major problems now...:(
1st - Mellanox FDR optical cable symbol error problems
I was used 20 FDR14 optical cable on 4036.
This cables works perfect on it.
But Mellanox 5035 Web GUI shows a symbol error on almost cables.
There is big question that is it support FDR14 optical cables or not?
My friend purchased same Mellanox 5035 QDR switch with Mellanox FDR14 Copper cables in good condition without any problems or any error message on it.
2nd - partition configuration problems
When I add each QDR HCA's port GUID with full membership to A partition then All member of the partition A can comunicate each others on 4036 QDR switch that I used previously.
But If I configure same step then I can't communicate each others.
Just only ALL=full configuration can communicate with each others.
How can I configure partition member on Web GUI or CLI.
I'm also configure ib0's MTU=4092, root nodes, system name and Subnet Manager.
Here is my hardware configurations.
15 of Mellanox MHZH29B-XTR with firmware 2.9.1200
1 of Mellanox MIS5035 with firmware 1.1.3000
20 of 15m Mellanox FDR14 Optical Cables
6 of Dell R610 Server with vSpehre ESXi 6.0 update 1
4 of SuperMicro Storage with OmniOS latest update
Is there any opinions don't hesitate give me a message.
Have a nice day...:)